Hampton Bay EC4157ABZ Instrukcja Użytkowania i Eksploatacji Pobierz pdf

LINE VOLTAGE FLEXIBLE TRACK LIGHTING

INSTRUCTION MANUAL

Please read carefully and save these instructions, as you may need them at a later date.

SAFETY

WARNING: RISK OF ELECTRIC SHOCK

Disconnect the electrical supply circuit before installing light fixture.

GENERAL

All electrical connections must be in accordance with local codes, ordinances or national electrical codes. If you are

unfamiliar with methods of installing electrical wiring, secure the services of a qualified electrician. Before starting installation,

disconnect the power by turning off the circuit breaker or removing the fuse at the fuse box.

INSTALLATION INSTRUCTIONS

CAUTION: MAKE SURE POWER IS TURNED OFF AT THE ELECTRICAL PANEL BOX BEFORE BEGINNING YOUR

INSTALLATION. TURNING POWER OFF AT WALL SWITCH IS NOT SUFFICIENT TO PREVENT ELECTRICAL

SHOCK

GENERAL

1. Be sure to read these installation instructions and review the diagrams thoroughly before installing the light fixture.

2. All electrical connections must be in accordance with local codes and the National Electrical Code. If you are unfamiliar

with methods of installing electrical wiring, secure the services of a qualified licensed electrician.

3. These fixtures are intended to be mounted to a 4" square x 2 1/8" deep metal octagon outlet box. The box must be

directly supported by the building structure.

4. Before starting the installation, disconnect the power by turning off the circuit breaker or by removing the appropriate

fuse at the fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.

Note: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and

situations that may occur. It must be understood that common sense, caution and care are factors that cannot be built

into any product. These factors must be supplied by the person(s) caring for, installing and operating the fixture.

IMPORTANT SAFETY INSTRUCTIONS

1. Read all instructions.

2. Do not install this lighting system in a damp or wet location.

3. Before energizing make sure that the lighting system is clear of all material which could cause a direct short and check

all electrical connections to make sure they are tight.

4. CAUTION – Hot surface, keep away from curtains and other combustible materials.

5. Lighted lamp is hot! Do not touch lamp at any time. Use a soft cloth or relamping tools (see diagram), Oil from skin may

damage lamp. Turn off power and allow bulbs to cool before replacing.

6. Lamp gets hot quickly! Contact only switch or plug when turning on. Do not touch hot lamp lens.

7. Do not conceal or extend bus-bar conductors through a building wall.

8. Do not install any part of this system (TRACK) less than 7 feet (2.2mm) above floor.

9. To reduce the risk of fire and burns, do not install this lighting system where non insulated open bus-bar conductors can

be shorted or contact any conductive metals.

10. To reduce the risk of fire and overheating, make sure all connections are tight.

11. Do not install any lamps closer than 6 inches (15.25cm) from any curtain or similar combustible material.

12. Turn off electrical power before modifying the light system in anyway.

13. Use minimum 20” spacing between stanchions when using 4 stanchions.

14. For use with EC series line voltage flexible track system only.

Do not cut any track sections.

15. CAUTION – To reduce the risk of a burn during relamping, remove from the track before relamping.

16. This track system is to be supplied by a single branch 120 volt circuit.

17. Disconnect electrical power before adding to or changing the configuration of the track.

READ AND SAVE THESE INSTRUCTIONS

1 2 3 4

Podsumowanie treści

Strona 1 - INSTALLATION INSTRUCTIONS

LINE VOLTAGE FLEXIBLE TRACK LIGHTING INSTRUCTION MANUAL Please read carefully and save these instructions, as you may need them at a later da

Strona 2

Tools Needed: Slotted screwdriver, Adjustable wrench, Electrical Hand drill, Step ladder, Wire cutters, Wiring supplies as required by electrical cod

Strona 3 - MANUAL DE INSTRUCCIONES

RIEL FLEXIBLE DE LUCES PARA TENSIÓN DE LÍNEA MANUAL DE INSTRUCCIONES Lea cuidadosamente y guarde estas instrucciones, porque puede necesitarla

Strona 4 - Adaptador de cosa fija

15. PRECAUCIÓN – Para reducir el riesgo de quemaduras durante el cambio de bombillas, retírelo del riel antes del cambio. 16. Este sistema de riel d

Komentarze do niniejszej Instrukcji

Brak uwag

Hampton Bay EC4157ABZ Instrukcja Użytkowania i Eksploatacji

Przeglądaj online lub pobierz Instrukcja Użytkowania i Eksploatacji dla Nie Hampton Bay EC4157ABZ. Hampton Bay EC4157ABZ Use and Care Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Hampton Bay EC4157ABZ